This is the the guide to help you connect AUTEL MS906 with the vehicle via the OBD cable.

1- connect the main cable’s 15pin female connector to the BD15 port on the top of the MaxiSys MS906 display tablet.

tighten the captive screws.

2- Connect the 16pin male connector of the main cable to the vehicle’s DTC, which is genrally located under the vehicle dash.

3- power up the display tablet. your MasiSys MS906 on Youobd2 is now ready for use as a diagnostic device.

http://autelscanner.blogspot.com/2017/09/autel-ms906-connection-instruction.html

To add a comment please login by clicking here